The IS9100 swing door operator may be installed on both new or existing single or double leaf doors.
The device may be used in automatic or manual mode (the latter also with power assistance), and is also available with a sliding arm for installation on the pull side or with a standard arm for installation on the push side of doors with a maximum frame jamb depth of 225 mm.
With over 40 settable parameters, the IS9100 is suitable for every possible application, and features many in-built functions such as high temperature overload protection and speed optimisation in relation to external operating conditions.
Technical features:
- Internal components of device protected by an elegantly styled casing measuring 70 mm in height
- Two operating modes: automatic or manual opening
- Over 40 settable parameters
PRODUCT: Swing door operator. For doors up to 1100 mm in width and 160 kg in weight. For internal doors and doors opening outwards.
Application conditions: - Ambient temperature: -15°C +50°C - Air humidity max. 93 % non-condensing - Power supply: 230 VAC +10%/-15%, 50Hz - Protection grade: IP 20 Dimensions (LxHxD): 685 x 70 x 130 mm Max. power input: 120 Watt Closing force EN1154: EN2-4 adjustable (also after installation) Max. door panel weight: 160Kg, (with “Full Energy” upgrade card) depending on the door panel width. Lintel depth: up to 225 mm Door panel width : 700 – 1100 mm Min. clearance between the hinges of the 2 door panels: 1500 mm Device weight: 12 kg Power supply for external devices: 24 VDC +/-5%, 1,5 A Door opening angle: max 110°, depending on the type of installation Fuse on power supply (not included): 16 A Noise during operation: max 50 dB Software (Firmware): on-site upgrading Signalling: - Leds: green, red, yellow - Display for programming Advanced features: - temperature related overload protection - driving speed automatic optimization
MAIN FEATURES: Speed adjustment. Hold open door adjustment. Safety sensor management Lock open input management Latching action adjustment Function “Push & Go” Emergency opening or closing programmable (Fail Safe or Fail Secure) Force adjustment from 2 to 4 according to standard EN1154 Opening angle adjustment: until 110° Low noise functioning (<50dB) Temperature overload protection Wind impact automatic adaptation Integrated in Iseo Access Control Systems It is possible to improve the door operator’s performance thanks to the upgrade card “full energy” for doors with weight over 120kg, doors separating rooms with different pressure and/or doors in locations with wind impact. INPUTS: Connecting terminals: max 1.5 mm2 Potential-free activator: internal and external (NO contact) Powered activator (intercom, key switch,...): - 8 – 24 VDC/AC + 5% - NO contact/NC contact Safety Sensor (intercom, key switch,...): - hinge side and opposite hinge side (NC contact) Test signal for safety sensor: hinge side and opposite hinge side Shutdown drive function: NC contact/NO contact OUTPUTS: Connecting terminals: max 1.5 mm2 Potential-free status contact (relais): Programmable - Door closed - Door open - Error - Door closed and locked INSTALLATION/ARM CONFIGURATION Sliding arm: pull side Sliding arm: push side (not suitable for fire resistant doors) Standard arm: push side Standard axle extension 9 mm (included) SWING DOOR OPERATOR IS9100 (without cover and arm) ARM AND ACCESSORIES: Single cover (silver) Standard arm Sliding arm Axle extension 30 mm Axle extension 60 mm Upgrade card “full energy”
